« previous next »
Pages: [1]

Author Topic: Connection Problem When I Use Arduino Start Lights  (Read 2639 times)

0 Members and 1 Guest are viewing this topic.

Flag Slot Racer

  • Been Here More than a Bit
  • ***
  • Posts: 41
    • View Profile
Connection Problem When I Use Arduino Start Lights
« on: March 06, 2016, 12:13:44 AM »
Every time I try and start up my Arduino for my start lights in combination with RCS64 I love connection with the Powerbase. It initially detects both fine, but after about 20 seconds I get an error message that the connection with the Powerbase was lost. So I am unable to use start lights with RCS64 at this point.  :(

Any idea of things to try? My Arduino is on com port 4.

Thanks,

Heath
Logged

martin

  • Administrator
  • Here a Real Lot!
  • *****
  • Posts: 276
  • RCS64 Programmer
    • View Profile
Re: Connection Problem When I Use Arduino Start Lights
« Reply #1 on: March 06, 2016, 10:39:54 AM »
I know there is a connection issue I hope I have solved this in the next version. You can make a quick fix by change the latency to 5ms.

Martin
Logged

Flag Slot Racer

  • Been Here More than a Bit
  • ***
  • Posts: 41
    • View Profile
Re: Connection Problem When I Use Arduino Start Lights
« Reply #2 on: March 06, 2016, 07:09:25 PM »
Changed the latency to 5ms but it didn't fix things. I'll just wait for the next update.

Heath
Logged

martin

  • Administrator
  • Here a Real Lot!
  • *****
  • Posts: 276
  • RCS64 Programmer
    • View Profile
Re: Connection Problem When I Use Arduino Start Lights
« Reply #3 on: March 06, 2016, 07:47:10 PM »
Sent us a mail if you want to test the upcomming release
Logged
Pages: [1]
« previous next »