I purchased RC64 last week and after being able to record one pace care session without using the controller I find myself unable to start any event from practice to qualifying or a race.
The controller is assigned to SSD controller status, the green light is on next to the driver on the start event tab, the controllers are indeed functioning (throttle configuration tab). Yet, when a click on practice and go to the screen to assign the controller to the car I'm able to do all steps and yet when countdown is over the car would not respond. Have tried both controllers without luck. Even went to a nuclear option and hit the reset RC64 to default settings button and still no luck.
If interest, when I stop the race I'm able to run the star with the appriayely assigned controller however no lap time is recorded. The only unusual message that I see is that flashing at the bottom of the start race window a message flashes stating latency might be too high for initializing (
). The only aspect I cannot change is eating either qualifying or racing to zero on the single event tab, something that apparently gets you in trouble from reading the v3 manual.
In summary, I can run my digital cars but cannot initiate a single event be it practice, qualifying, or racing. I was able to do so before I started working with the pace car feature, yet even after eliminating my two pace cars I cannot get the single event feature to work in terms of recording times or laps. Similar shortcoming on analog mode.
Any advise would be much appreciated as I believe to have tried all permutations including the box on the start menu window that request to check power on the vehicle on the track; it actually confirms the car has power but after I press the start button the car will not move.