Show Posts
1
Arduino / Sketch for a working pitllight using a normal standard digital scalex controller
« on: April 15, 2019, 01:25:21 PM »
Does anyone have a working Arduino sketch for a blinking LED when you open the PITmenu by means of a normal standard scalextric digital controller. (So no Smart Sensors and no Pit Pro). I have a working sketch for the reds, green and yellow leds but a working pitlight (in my case a blue led on pin 11 on an Arduino Uno board) sadly not works after many attempts.
You might know that the pit light (led on pin 11) is well working in the "Simple Arduino Test” utility on the Main Page Tab of the RCS64 software. I think when there is no pit data sending out of the RCS64 program to the Arduino board, than testing of the pit led (with stages off, on and blink) is also not possible.....or am I wrong?
.....but maybe it is a protocol problem.
Thanks in advance!
You might know that the pit light (led on pin 11) is well working in the "Simple Arduino Test” utility on the Main Page Tab of the RCS64 software. I think when there is no pit data sending out of the RCS64 program to the Arduino board, than testing of the pit led (with stages off, on and blink) is also not possible.....or am I wrong?
.....but maybe it is a protocol problem.
Thanks in advance!